d&b D12 Amplifier Quad Rack

Amplifier rack including 4x d&b D12 Amplifiers, 32a power distro and a dual NL4 to Socapex patch panel.

The two channel D12 amplifier delivers medium to high power into low impedance loads between 4 and 16 ohms and is ideally suited for use in both mobile and installation environments. The D12 contains setups for all d&b loudspeakers and a linear mode. The signal delay capability enables user definable settings of up to 340 msec (=100 m/328.1 ft) to be applied independently to each channel. The same applies to the 4-band parametric equalizer, providing optional boost/cut or notch filtering. The D12 incorporates a digital rotary encoder and a LCD display to configure the amplifier. The D12 utilizes an autosensing switch mode power supply for mains voltages 120 V/230 V, 50 – 60 Hz (optional 100/200V). RJ 45 connectors enable access to the Remote network via CAN-Bus. d&b System check verifies that the system performs within a predefined condition, whilst d&b Load monitoring enables an automatic and continuous impedance monitoring. Both can determine the status of an LF or HF driver in systems with multiple elements, even if these are crossed over passively.

Specification:

• Channels: 8
• Rated Power Output (per channel): 1600 4Ω
, 800W 8Ω

• 96 kHz/27 Bit ADC/24 Bit DAC
• Built-in DSP
• Inputs: 8x XLR(F) + XLR(M) Link
 Analogue + 4x XLR(F) + XLR(M) Link AES, 2x Ethercon CAN Bus Remote
• Outputs: 8x NL4, 8x EP5 (Wired Parallel)
• Power Input: 32A(M) Single Phase + 32A(F) Link output (Unprotected)